Workzilla
v260807.1
Stretch targets
7 August 2026 · Pat
Hi everyone,
Small release this time, but one a few of you have asked for. You can now set a stretch target alongside any target — a second number above the one you are actually measured against, for when the target is the floor rather than the ceiling.
New
Targets
Manage Targets
Stretch targets
You can now set a stretch target alongside any target — a second, higher number that sits above the target you are actually measured against. When you add or edit a target in Manage Targets, there is a new field next to the target amount: Target amount (stretch target). Put a value in it and the target carries both figures.
1
Target amount — the target that counts. Unchanged.
2
Target amount (stretch target) — the new field. Leave it empty and the target behaves exactly as it always has.
- The field appears on new targets and on existing ones — open any target to edit and it is there.
- The base target is still the number you are measured against. The stretch sits on top of it — an extended number to aim past, not a replacement. A common approach is to set it around 110% of the target.
- Any target with a stretch value applied shows a dotted overlay on the target charts. The solid line is still the base target.
- To see other people’s stretch targets, go to Targets. For your own, go to My Performance → Targets.
1
Solid line — the base target.
2
Dotted line — the stretch target.
3
Legend — the two are labelled “Target” and “Target (stretch)”.
As always, tell us how you find it — particularly whether the stretch line reads clearly on the charts once you have a few months of data behind it.
Pat